Craftsman 917.274750 User Manual

Page 29

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center

PROBLEM

CAUSE

CORRECTION

Will not start

1. Out of fuel.

1. Fill fuel tank.

2.

Engine not “CHOKED”

2. See “TO START ENGINE”

properly.

in Operation section.

3. Engine flooded.

3. Wait several minutes

before attempting to start.

4.

Bad spark plug.

4.

Replace spark plug.

5.

Dirty air filter.

5. Clean/replace air filter.

6. Dirty fuel filter.

6. Replace fuel filter.

7

Water in fuel.

7. Empty fuel tank and carbure­

tor, refill tank with fresh gas­
oline and replace fuel filter.

8.

Loose or damaged wiring.

8. Check all wiring.

9. Carburetor out of adjustment.

9. See “To Adjust Carburetor”

in Service and Adjustments
section.

10 Engine valves out of

10 Contact a Sears or other

adjustment.

qualified service center.

Hard to start

1. Dirty air filter.

1. Clean/replace air filter.

2.

Bad spark plug.

2.

Replace spark plug.

3. Weak or dead battery.

3. Recharge or replace battery.

4.

Dirty fuel filter.

4.

Replace fuel filter.

5. Stale or dirty fuel.

5.

Empty fuel tank and refill tank

with fresh, clean gasoline.

6. Loose or damaged wiring.

6. Check all wiring.

7. Carburetor out of adjustment.

7. See “To Adjust Carburetor”

in Service and Adjustments
section.

8.

Engine valves out of

8. Contact a Sears or other

adjustment.

qualified service center.

Engine will not

1. Clutch/brake pedal not

1. Depress clutch/brake pedal.

turn over

2.

depressed.
Attachment clutch is engaged.

2.

Disengage attachment clutch.

3. Weak or dead battery.

3. Recharge or replace battery.

4.

Blown fuse.

4.

R©pi3C© fus©.

5. Corroded battery terminals.

5. Clean battery terminals.

6. Loose or damaged wiring.

6. Check all wiring.

7. Faulty ignition switch.

7. Check/replace ignition switch.

8.

Faulty solenoid or starter.

8. Check/replace solenoid or

starter.

9. Faulty operator presence

9. Contact a Sears or other

switch(es).

qualified service center.

Engine clicks but

1. Weak or dead battery.

1. Recharge or replace battery.

will not start

2. Corroded battery terminals.

2. Clean battery terminals.

3. Loose or damaged wiring.

3. Check all wiring.

4.

Faulty solenoid or starter.

4. Check/replace solenoid or

starter.

29

Advertising