Secure the throttle cables, Zip tie, Adjusting the throttle grip – Craftsman 316.794801 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
ASSEMBLY INSTRUCTIONS
The completed blower tube should look like Figure 6.
A
WARNING:
To avoid serious personal Injury, make
sure that the blower tubes are locked In place or firmly
Installed.
Secure the Throttle Cables
Place a zip tie around the elbow tube and the throttle cables (Fig.
7) as shown, making sure not to crimp the cables.
□
Zip Tie
Adjusting the Throttle Grip
1.
Move the throttle grip to a location on the upper blower tube
that Is comfortable for you (Fig. 8).
2.
Using a Torx T-20 Torx screwdriver, tighten the two screws at
the bottom of the throttle grip (Fig. 9).
Advertising