Craftsman 917.273840 - Manual (Page 55)

TRACTOR - - MODEL NUMBER 917.273840
KOHLER ENGINE-MODEL NUMBER SV530,TYPE NUMBER 0005
STARTING SYSTEM
KEY PART
NO. NO.
ENGINE CONTROLS
DESCRIPTION
1 20 098 01-S
2
OIL PAN/LUBRICATION
Starter assembly, inertia
drive
25 100 31 -S Nut, hex. serrated flange (2)
KEY PART
NO. NO.
1 20 040 02-S
2 20 153 01-S
3 20 009 03-S
4 25 139 60-S
5 52 050 02-S
6 20 041 01-S
7 20 096 02-S
8 20 041 02-S
9 20 144 03-S
10 20 310 03-S
11 12 380 01-S
12 M-545013-S
13 M-851030-S
14 20 032 01-S
15 25 15502-S
DESCRIPTION
Kit, dipstick assembly (In
eludes 2)
0-Ring, dipstick (2)
Plate assembly,
closure(lncludes 4,10,11)
Plug, pipe (2)
Filter, oil
Gasket, closure plate
Kit, oil passage cover (In
eludes 8)
Gasket, oil passage
Shaft, governor gear
Kit, gear and \weight
assembly(lncludes 11)
Pin, governor regulating
Screvif, hex. flange
M5x0.8x13(6)
Scre\w, hex. flange
M8x1.25x30 (14)
Seal, oil
Connector 90 degrees
KEY PART
NO. NO.
1
2
3
5
6
7
8
9
10
11
12
13
14
15
20 536 03-S
12 237 01-S
24 086 43-S
M-664020-S
20 079 02-S
12 089 11-S
20 08610-S
20 090 02-S
52 211 04-S
X-22-11-S
12 100 07-S
20 089 07-S
25 158 11-S
20 079 01-S
25 158 08-S
DESCRIPTION
Control assembly, speed
Clamp, cable
Screvif, torx hd. ctsk.
M5x0.8x16
Screvif, lobed sekt.
M6x1.0x20 (2)
Linkage, choke - single wire
Spring, speed control
Screw, thread forming
M4x0.7x25
Lever, governor
Bolt, round head 1/4-20x1"
Washer, lock 1/4”
Nut, hex. flange 1/4-20”
Spring, governor
Bushing, throttle linkage
Linkage, throttle
Bushing, linkage retaining
NOTE: All component dimensions given in U.S.
inches 1 inch = 25.4 mm
55