Know your trim saw, Switch, Applications – Craftsman 315.271190 User Manual
Page 7: Product specifications, Features
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FEATURES
KNOW YOUR TRIM SAW
See Figure 1.
Before attempting to use your trim saw. familiarize yourself
with all operating features and safety requirements.
Features include easily operated bevel cut and depth of
cut adjustment mechanisms; positive 0° bevel stop;
spindle lock; and blade wrench storage.
A WARNING;
Carefully read through this entire
owner’s manual before using your new trim saw. Pay
close attention to the Rules For Safe Operation,
Warnings and Cautions. If you use your trim saw
properly and only for what it is intended, you will enjoy
years of safe, reliable service.
Your trim saw has been shipped completely assembled
except for the blade. Inspect it carefully to make sure no
breakage or damage has occurred during shipping. If any
parts are damaged or missing, contact your nearest Sears
Retail Store to obtain replacement parts before attempting
to operate saw. A blade, blade wrench (5 mm hex key), rip
guide (edge guide) and this owner's manual are also
included.
A WARNING
: Do not allow familiarity with your saw to
make you careless. Remember that a careless fraction
of a second is sufficient to inflict severe injury.
SWITCH
Your saw is equipped with a lock-off button which reduces
the possibility of accidental starting. The lock-off button is
located on the handle above the switch trigger. You must
depress the lock-off button in order to pull the switch
trigger. The lock resets each time the trigger is released.
Note:
You can depress the lock-off button from either the
left or right side.
APPLICATIONS
(Use only for the purposes listed below)
■ Cutting all types of wood products (lumber, plywood,
paneling).
A WARNING:
If any parts are missing, do not operate
your saw until the missing parts are replaced. Failure to
do so could result in possible serious personal injury.
PRODUCT SPECIFICATIONS:
TRIM SAW
315.271190
Blade Diameter
6-1/2 in. (165 mm)
Blade Arbor
3/8 in. (10 mm)
Cutting Depth at 90°
2-1/8 in. (54 mm)
Cutting Depth at 45°
1-5/8 in. (42 mm)
No load Speed
2,500 RPM
Motor
18 Volts DC
CHARGER
ITEM NO.S-11040
(981399-001)
Input
120
V,
60 Hz, AC only
Charging Voltage
9.6 - 24 Volts
Charge Rate
1 Hour
BATTERY PACK
ITEM NO. g-11034
(981404-001)