Craftsman F1294 - Manual (Page 3)

Call 1-800-366-7278 for Service Parts
Refer to Service Parts Drawing for full listing of Service Parts
HARDWARE:
" ,» 14-10 X m PHILLIPS SCREW
14-10 X 56 HEX SCREW
ASSEMBLY
SIDE HANDLE ATTACHMENT:
NOTE: Holes in the handle are tapped
requiring no nuts for installation.
• Attach the side handle using (4) 14-10 x
3/4 Phillips screws. Do not over tighten
screws.
n :
Cl
CASTER INSTALLATION:
NOTE: Use adequate manpower for this
operation.
• Lay the cart down on its back. Use
packaging material to protect the paint
finish.
• Mount both swivel casters on the same
side of the cart.
Attach each caster using (4) 14-10x5/8
hex screws per caster.
Wrench tighten all screws.
Return the cart to its upright position.
OPERATION
REMOVING AND INSTALLING
DRAWERS:
• Empty the drawer.
• Fully extend the drawer.
• Depress the release tab on both sides,
(this allows the slides to ride over the
stops). Pull out to remove
• To reinstall, carefully align the slides and
slowly push the drawer into the unit until
the drawer stops.
Release
Left
Release
Right
To remove the slide from the unit, first
remove the drawer (follow the procedure
above). Lift and hold the spring retainer,
and push the slide upward. The slide
may now be removed.