Operation – Craftsman 973.111430 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10/03/01 WED 13:46 FAX 864 964 3314 RYOBI CUSTOMER SERVICE
®012/015
OPERATION
Note; Remember the two-speed feature (Hl-LO) when
setting torque. The amount of torque will vary depend
ing on which speed setling you have your drill-driver.
Switching to LO speed will increase torque. Switching
to HI speed will decrease torque.
BIT STORAGE
See Figure JO.
When not In use, bits provided with your drill can be
placed in the storage area located on the top of your
drill as shown In Figure 10.
drilling
See Figure 12.
iV WARNING:
Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being Thrown into your eyes, resulting in possible
serious injury.
LEVEL DRILLING
See Figure 11.
A convenient new feature provided with your drill Is a
level. It Is recessed in the motor housing on top of
your drill. It can be used to keep drill bits level during
drilling operations.
When drilling hard smooth surfaces use a center
punch to mark desired hole location. This will prevent
the drill bit from slipping oft center as the hole is
started. However, the low speed feature allows
starting holes without center punching if desired. To
accomplish this, simply operate your drill at a low
speed until the hole is started.
The material to be drilled should be secured In a vise
or with clamps to keep it from turning as the drill bit
rotates.
Hold tool firmly and place the bit at the point to be
drilled. Depress the switch trigger to start tool.
Move the drill bit into the workpiece applying only
enough pressure to keep the bit cutting, Do not force
of apply side pressure to elongate a hole.
/V WARNING:
Be prepared for binding or bit
breakthrough. When these situations occur, drill
has a tendency to grab and kick opposite to the
direction of rotation and could cause loss of
control when breaking through material. If not
prepared, this loss of control can result in
possible serious injury.
When drilling metals, use a light oil on the drill bit to
keep I
t
from overheating. The oil will prolong the life of
the bit and increase the drilling action.
If the bit jams in workpiece or If the drill stalls, release
switch trigger immediately. Remove the bit from the
workpiece and determine the reason for jamming.