Craftsman 536.772200 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PRODUCT SPECIFICATIONS
HORSE POWER:
3.8
DISPLACEMENT:
10 cu. in. (163cc)
GASOLINE CAPACITY: 1.25 qt.
(unleaded regular)
LUBRICATION:
20 oz. SAE-30W
SPARK PLUG:
Champion RJ19LM
(Gap .030)
or Equivalent
GENERAL RECOMMENDATIONS
The warranty on this Edger does not cover
items that have been subjected to operator
abuse or negligence. To receive full value
from the warranty, the operator must main
tain the Edger as instructed in this manual.
The above chart is provided to assist the
operator in properly maintaining the Edger.
LUBRICATION
• After each 25 hours of use of your Edger,
apply light machine oil to all moving
parts.
• We recommend that the oil in the engine
crankcase be changed after each 25
hours of use thereafter.
NOTE:
If the Edger is being used in sandy
or dusty areas, change the oil more fre
quently to prevent premature engine wear.
TO CHANGE ENGINE OIL
• Disconnect the spark plug wire from the
spark plug.
• Remove the oil drain plug as shown in
first figure on this page and drain the oil
into a flat pan.
• After draining all the oil, reinstall the oil
drain plug securely.
NOTE:
The oil will drain more freely when
the engine is warm.
• Remove the oil fill cap/dipstick. See first
figure on page 9.
• Fill the engine crankcase, pouring slowly.
DO NOT OVERFILL.
For approximate ca
pacity see
PRODUCT SPECIFICA
TIONS
on this page.
NOTE:
The quill assembly bearings are
factory sealed and wilt require no lubrica
tion.
• Reconnect the spark plug wire on the
spark plug.
Replace the filter once a year; more often
under dusty or dirty conditions.
DO NOT
attempt to clean or oil the air filter.
To install a new air filter, do the following:
• Disconnect the spark plug wire from the
spark plug.
• Turn the cover as shown below to the left
(counterclockwise) and remove the cover
and the air filter from the flange.
• Discard the air fitter.
• Clean the cover and the flange thor
oughly.
• Insert the new air fitter into the cover.
• Push the cover firmly against the flange
and turn it to the right (clockwise) as far
as it will go as shown in figure below. Be
sure the retainers are locked around the
flange.
• Reconnect the spark plug wire.
ATum cover to the left
I
(counterclockwise)
T to remove
Cover
Flange*
Turn cover
to the right
(clockwise)
to install
11