Service and adjustments – Craftsman 917.773423 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
A CAUTION:
Before performing any
service and adjustments:
1. Stop engine.
2. Make sure the rotating lines and all
moving parts have completely
stopped.
3. Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
TRIMMER
TO ADJUST TRIMMING HEIGHT
See "TO ADJUSTTRIMMING HEIGHT' in the
Operation section of this manual.
TO ADJUST HANDLE
The upper handle may be adjusted to
different height positions.
• Loosen handle knob only enough to
allow the upper handle to pivot to the
desired position.
• Tighten handle knob securely.
NOTE:
The handle knob and bolt may be
reversed for left handed operation.
Upper handle
TO REMOVE/REPLACE TRIMMER HEAD
DRIVE BELT
1. Remove screw at front of chassis
cover.
2. Lift cover up and away from trimmer.
Screw
3.
4.
5.
6
.
7.
Remove the two (2) so'ews on sides
of trimmer securing the debris shield.
Turn trimmer on its side with carbure
tor and fuel cap up.
Remove the two (2) screws on
underside of trimmer securing the
debris shield.
Slide the debris shield rearward and
remove.
Remove belt from engine pulley on
crankshaft.
Engine
pulley
Debris shieid screws
13