Craftsman 917.271820 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

* Do not push or tow tractor at more than

two <2) MPH.

• To reengage transmission, reverse

above procedure.

NOTE:

To protect hood from damage

when transporting your tractor on a truck
or a trailer, be sure hood is closed and
secured to tractor. Use an appropriate
means of tying hood to tractor (rope, cord,
etc.).

1

-+ = ^

TOWING CARTS AND OTHER
ATTACHMENTS

Tow only the attachments that are
recommended by and comply with
specifications of the manufacturer of your
tractor. Use common sense when towing.

Too heavy of a load, while on a slope, is

dangerous. Tires can lose traction with

the ground and cause you to lose control

of your tractor.

BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL

The engine in your tractor has been
shipped, from the factory, already filled
with summer weight oil.

1. Check engine oil with tractor on level

ground.

2. Remove oil fill cap/dipstick and wipe

clean, reinsert the dipstick and screw
cap tight, wait for a few seconds,

remove and read oil level. If neces­

sary, add oil until “FULL” mark on
dipstick is reached. Do not overfill.

• For cold weather operation you should

change oil for easier starting (See “OIL
VISCOSITY CHART’ in the Mainte­
nance section of this manual).

• To change engine oil, see the Mainte­

nance section in this manual.

ADD GASOLINE

• Fill fuel tank. Use fresh, clean, regular

unleaded gasoline with a minimum of
87 octane. (Use of leaded gasoline
will increase carbon and lead oxide
deposits and reduce valve life). Do not
mix oil with gasoline. Purchase fuel in
quantities that can be used within 30
days to assure fuel freshness.

IMPORTANT;

When operating in

temperatures below 32°F(0°C), use fresh,
clean winter grade gasoline to help

insure good cold weather starting.

^WARNING:

Experience Indicates that

alcohol blended fuels (called gasohol or

using ethanol or methanol) can attract
moisture which leads to separation and

formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage. To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or

longer. Drain the gas tank, start the

engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel

next season. See Storage Instructions for

additional information. Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.

A CAUTION:

Fill to bottom of gas tank

filler neck. Do not overfill. Wipe off any
spilled oil or fuel. Do not store, spill or

use gasoline near an open flame.

TO START ENGINE

When starting the engine for the first time or if
the engine has run out of fuel, it will take
extra cranking time to move fuel from the
tank to the engine.

1. Be sure freewheel control is in the

transmission engaged position.

Sit on seat in operating position,
depress clutch/brake pedal and set
parking brake.
Place motion control lever in neutral

(N) position.
Move attachment clutch to “DISEN­
GAGED" position.
Move throttle control to fast position

Pull choke control out for a cold
engine start attempt. For a warm
engine start attempt the choke control
may not be needed.

NOTE:

Before starting, read rtie warm and

cold starting procedures below.
7. Insert key into ignition and turn key

clockwise to “START position and

release key as soon as engine starts.
Do not run starter continuously for
more than fifteen seconds per minute.
If the engine does not start after

several attempts, push choke control

in, wait a few minutes and try again. If

engine still does not start, pull the
choke control out and retry.

2

.

16

Advertising