Craftsman 247.370480 - Manual (Page 15)

SERVICE AND MAINTENANCE
J
RESETTING CIRCUIT BREAKER RESET
BUTTON
This mower is equipped with an circuit breaker reset button to prevent
overheating damage to the motor.
If the circuit breaker reset button pops out:
1. Release the motor/blade control handle and do NOT re-start the
mower for at least one minute, allowing for the motor time to cool.
2. Press the circuit breaker reset button inward to reset. See
Figure 14.
If the circuit breaker reset button pops out shortly after resetting:
1. Release the motor/blade control handle and do NOT re-start the
mower for at least 15 minutes to allow the motor extra time to
cool.
2. Press the circuit breaker reset button inward to reset.
3. Restart unit.
NOTE: If the circuit breaker reset button pops out repeatedly
during operation or will not remain in when attempting to reset,
contact your nearest Sears Service Center to arrange for repair.
BATTERY CARE
IMPORTANT: Replace with only the identical battery provided with
this mower (Part number 725-04381A). The battery should only be
replaced by a Sears Service Center.
• Do not store unit below -20 degrees Celsius (-4 degrees F).
• Store the mower fully charged. Charging the unit every two
months during storage will provide additional insurance that the
batteries will not suffer any capacity loss.
• These batteries will not leak and can be stored on their sides.
AWARNING
Due to a potential shock hazard, DC NCT attempt to remove the
motor/battery shroud. There are no user serviceable parts inside.
Contact your nearest Sears Service Center if repairs are needed.
AWARNING
Always stop the motor and remove key before cleaning, lubricating
or performing any repairs or maintenance on the lawn mower. Always
wear safety glasses during operation or while performing any adjustments
or repairs.
MAINTENANCE SCHEDULE
Follow the maintenance schedule given below. This chart describes
service guidelines only. Use the Service Log column to keep track of
completed maintenance tasks. To locate the nearest Sears Service
Center or to schedule service, simply contact Sears at
1-800-4-MY-HOME®.
Interval Item Service Service Log
Each Use 1. Mower blades 1. Sharpen as required
2. Loose or missing hardware 2. Tighten or replace
3. Controls 3. Check for proper operation
4. Motor 4. Remove any buildup of grass and
leaves on or around the motor cover
(do not use water).
5. Deck
5. Clean underside of deck with a
suitable tool (do not use water).
Annually or 25 hours 1. Wheels 1. Lube with light oil
2. Rear discharge door and
side mulch plug 2. Lube torsion spring and pivot point
with light oil.
3. Mower blades 3. Sharpen and balance
Before Storage 1. Battery 1. Fully charge
During Storage 1. Battery 1. Charge every two months
15