Storage – Craftsman 917.271653 User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STORAGE

Immediately prepare your tractor for

storage at the end of the season or if the
tractor will not be used for 30 days or

more.

^CAUTION; Never store the tractor with

gasoline in the tank inside a building

where fumes may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure.

TRACTOR

Remove mower from tractor for winter

storage. W hen mower is to be stored for

a period of time, clean it thoroughly,
remove all dirt, grease, leaves, etc. Store
in a clean, dry area.
1. Clean entire tractor (See “CLEANING”

in the Maintenance section of this
manual).

2. Inspect and replace belts, if necessary

(See belt replacement instructions in

the Senrice and Adjustments section

of this manual).

3. Lubricate as shown in the Mainte­

nance section of this manual.

4. Be sure that all nuts, bolts and screws

are securely fastened. Inspect moving
parts for damage, breakage and wear.
Replace if necessary.

5. Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

BATTERY

• Fully charge the battery for storage.
• After a period of time in storage, battery

may require recharging.

• To help prevent corrosion and power

leakage during long periods of storage,
battery cables should be disconnected
and battery cleaned thoroughly (see
“TO CLEAN BATTERY AND TERMI­
NALS” in the Maintenance section of
this manual).

• After cleaning, leave cables discon­

nected and place cables where they
cannot come in contact with battery
terminals.

• If battery is removed from tractor for

storage, do not store battery directly on
concrete or damp surfaces.

ENGINE
FUELSYSTEM

IMPORTANT: It is important to prevent

gum deposits from forming in essential
fuel system parts such as carburetor, fuel
hose, or tank during storage. Also,

alcohol blended fuels (called gasohoi or

using ethanol or methanol) can attract

moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage.

1. Drain the fuel tank.

2. Start the engine and let it run until the

fuel lines and carburetor are empty.

• Never use engine or carburetor cleaner

products in the fuel tank or permanent
damage may occur.

• Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable

alternative in minimizing the formation of
fuel gum deposits during storage. Add
stabilizer to gasoline in fuel tank or
storage container. Always follow the mix

ratio found on stabilizer container. Run
engine at least 10 minutes after adding

stabilizer to allow the stabilizer to reach
the carburetor. Do not drain the gas tank

and carburetor if using fuel stabilizer.
ENGINE OIL

Drain oil (with engine warm) and replace

with clean engine oil. (See “ENGINE” in
the Maintenance section of this manual).

CYLINDER(S)

1. Remove spark plug(s).

2. Pour one ounce of oil through spark

plug hole(s) into cylinder(s).

3. Turn ignition key to start position for a

few seconds to distribute oil.

4. Replace with new spark plug(s).

OTHER

• Do not store gasoline from one season

to another.

• Replace your gasoline can if your can

starts to rust. Rust and/or dirt in your
gasoline will cause problems.

• If possible, store your tractor indoors

and cover it to give protection from dust
and dirt.

• Cover your tractor with a suitable

protective cover that does not retain
moisture. Do not use plastic. Plastic

cannot breathe which allows conden­
sation to form and will cause your
tractor to rust.

IMPORTANT: Never cover tractor while

engine and exhaust areas are still warm.

27

Advertising