Assembly – Craftsman 536.772101 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
HOW TO RAISE THE HANDLE
2
.
3.
Loosen the
knobs
and raise the upper
handle to the upright position. See
Figure 2.
Tighten the
knobs.
Make sure the
knobs
are to the outside of the handles
as shown in Figure 2.
Insert the end of the
control rod,
from
RIGHT to LEFT, through the hole in the
front wheel arm.
Attach with
hair pin
found in parts bag. See Figure 3.
Push down on the handle to tilt the unit
back.
5. Insert the other end of the
control rod,
from RIGHT to LEFT, through the hole in
the
depth control lever
and fasten with
hair pin.
See Figure 4.
6. Move the
depth control lever
forward to
the STARTING and TRANSPORT posi
tion.
7. Remove any packing material from the
bottom of the unit.
8. To attach the
recoil starter rope
to the
rope guide,
twist the
recoil starter rope
through the
rope guide.
See Figure 5.
Front
Wheel Arm
Hair Pin
Control
Rod
F-001101M
Figure 3