Starting a cut important, Blades perpendicular to workpiece approximately 30, Warning; always – Craftsman 286.26829 User Manual
Page 12: Operatíon coiit
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERAtíON coiit.
STARTING A CUT
IMPORTANT;
BEFORE
using the Twin Cutter Saw for the first time,
ALWAYS
familiarize yourself
with tire saw by making practice cuts in scrap rnateriais.
The weight of this saw helps to make the cuts smoother. Learn how to safely handle
and control the weight of the saw.
ALWAYS
be sure that you position the blades perpendicular to the plane of the
workpiece. Make the cut at an approximate 30" angle to the workpiece surface.
(See Fig. 5).
Practice the proper feed speed rate for 1!ie materials being cut. The blades spin at a
consistent 4600 RPM {no-load speed).
Engage the on/off switch to start the saw,
ALWAYS
let the blades reach
full
speed
before you begin the cut into the workpiece.
IMPORTANT: When using your saw, ALWAYS stay alert and exercise control.
DO NOT remove your saw from the workpiece, while the blade is moving.
Blades perpendicular to workpiece
Approximately 30"
WARNING;
always
maintain proper control of the saw
to make sawing safer and easier.
Loss of control of the saw could
cause an accident resulting in
possible serious injury.
NEVER
hold the saw with just
one hand (see Fig. 6).
always
hold saw by motor body anc
assist handle (see Fig, 7).
12