Craftsman 917.249392 - Manual (Page 10)

? 0. Place L.H. baffle (Fig. 4) on lip of mower housing.
Secure L .H, runner to L.H. baffle and mower hous­
ing using: two 5/16 carriage bolts and two 5/16
locknuts (shown full size below) NOTE: Do not
tighten. L.H baffle and hardware furnished with
bagger.
1 1 Using a 1/2" wrench remove hardware "D" (Fig.
5 - Inset) securing discharge guard to mower hous­
ing. Hardware may be discarded.
1 2. Using a 1/2” wrench remove hardware "A", "8"
and "C" (Fig. 6) securing R.H. runner to mower
housing. Hardware may be discarded.
Place R.H. baffle (Fig. 4) on lip of mower housing.
Secure R.H. runner to R.H. baffle and mower hous­
ing using: one 5/16 carriage bolt and one 5/16
locknut (shown full size below) NOTE: Do not
tighten. R.H. baffle and hardware furnished with
grass catcher.
13
14. Secure L.H. baffle and R.H. baffle to mower hous­
ing using: four clamps, four 1/4 hex bolts and four
1/4 locknuts (shown full size below). Clamps and
hardware furnished with grass catcher.
m
15
a. Place clamps (Fig. 7) over holes in L.H. and R.H.
baffles (Fig. 7). Bolt heads to underside of
mower
housing. Tighten securely. NOTE:
Tighten hardware assembled in step 10
securely.
Assemble latch assembly to top of R.H. runner (Fig.
8) using: two 5/16 carriage bolts and two 5/16
locknuts (shown full size below). Bolt heads to
underside of mower housing. NOTE: Do not tighten.
Latch assembly and hardware furnished with grass
catcher.
10