HP 49g Graphing Calculator - Manual (Page 82)

Plot setup parameters
Type
EQ
Indep
Depnd
Connect
H-Tick
V-Tick
Pixels
The angle imits field indicates the units in which angular
arguments are to be interpreted: degrees, radians, or
gradians.
The equation(s) you want to plot. It defaults to the
equations listed on the Plot - Conic screen but it can be
changed on the Plot Setup input foi'm.
The name of the independent variable.
The name of the dependent variable.
Wlren checked—which is the default setting—the plotted
points are connected to fonn a line or curve; when
imchecked, only the plotted points are displayed.
The niunber of imits (or pixels) between tick marks on
the horizontal axis. The default is one tick every 10 pixels.
Whether imits or pixels is used depends on the setting in
the Pixels field (see below).
This field is only available if you have chosen to display
axes. Press (£4) to include or exclude axes.
The niunber of pixels or imits between tick marks on the
vertical axis. The default is one tick every 10 pixels.
Whether imits or pixels is used depends on the setting in
the Pixels field (see below).
This field is only available if you have chosen to display
axes. Press (R) to include or exclude axes.
Wlien checked—which is the default—the values in the
H-Tick and V-Tick fields are interpreted as pixels. Wlien
imchecked, these values are interpreted as units.
This field is only available if you have chosen to display
axes. Press (F4) to include or exclude axes.
The type of plot (in this case, conic).
Page 4-14 Plotting graphs