Craftsman 247.370320 - Manual (Page 12)

TROUBLE SHOOTING GUIDE
Trouble Possible Cause(s) Corrective Action
Does not start 1. Motor/blade control disengaged.
2. Extension cord disconnected.
3. Blown fuse or a tripped circuit breaker.
4. Motor/biade control switch defective.
1. Engage motor/blade control.
2. Be sure that the extension cord is plugged
into the outlet and the lawn mower
switch plug.
3. Check to see if a fuse has been blown or
a circuit breaker tripped in your
electrical box.
4. Replace motor/blade control switch.
Frequent blowing of fuses 1. Cutting too much grass.
2. Circuit overloaded.
1. Set in “Higher Cut" position.
2. Do not use a higher rated fuse without
consulting your power company.
If condition persists (be sure circuit is not
overloaded), have your unit checked by
your nearest Authorized Sears Sen/ice
Dealer.
Loss of power 1. Cutting too much grass.
2. Build-up of grass, leaves and debris under
mower.
1. Set in “Higher Cut” position.
2. Disconnect power cord and clean underside
of mower housing.
Poor or uneven cut 1. Worn, bent or loose blade.
2. Build-up of grass, leaves and debris under
mower.
1. Replace blade. Tighten blade nut.
2. Disconnect power cord and clean underside
of mower housing.
Too much vibration 1. Worn, bent or loose blade.
2. Bent motor shaft.
1. Replace blade. Tighten blade nut.
2. Contact Sears Service Department.
Hard to push 1. High grass or cutting height too low.
2. Rear of mower housing and blade dragging
in heavy grass.
1. Raise cutting height
2. Raise cutting height.
Note: For repairs beyond the minor adjustments listed above, contact your nearest SEARS Service Center.
The use of any accessory on this Rotary Mower other than those manufactured by the mower manufacturer is not
recommended.
À WARNING: DO NOT operate the mower without the entire grass catcher or chute deflector in place.
DO NOT operate the mower without the protective shield on the rear of the deck in place.
12