A warning, Accessories carton contents, Warning – Craftsman 183.172530 User Manual
Page 6: Cutting tool components
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ACCESSORIES
CARTON CONTENTS
AVAILABLE ACCESSORIES
UNPACKING AND CHECKING CARTON CONTENTS
A WARNING
A WARNING
Use only accessories recommended for this cutting
tool. Follow instructions that accompany accessories.
Use of improper accessories may cause injury to the
operator or damage to the cutting tool.
Visit your
Sears Hardware Department or see the Sears
Power andftand Tool Catalog for an assortment of
accessories recommended for use with this cutting tool:
Flex Drive
Rip Guide
Router
Circle Cutter
Cutting Bits
Hobby Rotary Tool Accessories
Cutters
Polishers
Sanders
Grinders
A
WARNING
Use only accessories designed for this cutting tool to
avoid severe injury or tool damage.
Do not use any accessory unless you have
completely read the instructions or Owner's Manual
for that accessory.
If any part is missing or damaged, do not plug the
cutting tool into the power source until the missing
or damaged part is replaced and assembly is
complete.
Carefully unpack the cutting tool and all its components.
Compare against the “Cutting Tool Components" chart
below.
NOTE: See Page 7 for illustration of components.
A
WARNING
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the cutting tool.
CUTTING TOOL COMPONENTS
"KEYHI DESCRIPTION | QTY
Cutting Tool Box
A
Cutting Tool
1
B
Collet Wrench
1
C
Collet Wrench Holder
1
D
Owner's Manual
1
Accessory Box
E
Precision Handle with Soie Plate I 1
F
Freehand Sole Plate Attachment 1
G
1/8" Collet Sleeve 1
H
1/4" Collet Sleeve 1
1
Lateral Style Drvwall Cutter 1
J
Wood / Plastic / Fiberglass Cutter | 1
NOTE: The two most commonly used cutters are
included with this tool (items I & J). It is Important
that you use the correct cutter to ensure the most
efficient cutting action.
•
Use cutter T’ with the finer spiral for cutting
drywatl.
•
Use the general purpose cutter “J” with the
coarser spiral for cutting materials such as wood,
plastic and fiberglass.