Storage – Craftsman 358.794941 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STORAGE

a WARNING:

Perform the following

steps after each use:
• Allow engine to cool, and secure the

unit before storing or transporting.

• Store unit and fuel in a well venti­

lated area where fuel vapors cannot
reach sparks or open flames from

water heaters, electric motors or

switches, furnaces, etc.

• Store unit with all guards in place.

Position unit so that any sharp object

cannot accidentally cause injury.

• Store unit and fuel well out of the

reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of sea­

son or if it will not be used for 30 days

or more.
If your unit is to be stored for a period
of time:
• Clean the entire unit before lengthy

storage.

• Store in a clean dry area.
• Lightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA­

TION section of this manual, see mes­

sage labeled IMPORTANT regarding
the use of gasohol in your engine.

Fuel stabilizer is an acceptable alterna­

tive in minimizing the formation of fuel

gum deposits during storage. Add stabi­
lizer to gasoline in fuel tank or fuel stor­
age container. Follow the mix instruc­

tions found on stabilizer container. Run

engine at least 5 minutes after adding

stabilizer.

Craftsman 40:1,2-cycle engine oil (air
cooled) is already blended with fuel
stabilizer, if you do not use this Sears
oil, you can add a fuel stabilizer to your

fuel tank.

ENGINE

• Remove spark plug and pour 1 tea­

spoon of 40:1,2-cycle engine oil (air
cooled) through the spark plug open­

ing. Slowly pull the starter rope 8 to

10 times to distribute oil.

• Replace spark plug with new one of

recommended type and heat range.

• Clean air filter.
• Check entire unit for loose screws,

nuts, and bolts. Replace any dam­

aged, broken, or worn parts.

• At the beginning of the next season,

use only fresh fuel having the proper

gasoline to oil ratio.

OTHER

• Do not store gasoline from one sea­

son to another.

• Replace your gasoline can if it starts

to rust.

TROUBLESHOOTING TABLE

A WARNING:

Always stop unit and disconnect spark plug before perform­

ing any of the recommended remedies below other than remedies that re­

quire operation of the unit.

TROUBLE

CAUSE

REMEDY

Engine wilf not

start.

1. Engine flooded.

2. Fuel tank empty.
3. Spark plug not firing.

4.

Fuel not reaching

carburetor.

5. Compression tow.

1, See "Starting a Flooded Engine”

in Operation section,

2, Fill tank with correct fuel mixture.

3, Install new spark plug.
4, Check for dirty fuel filter; replace.

Check for kinked or split fuel line;
repair or replace.

5, Contact Sears Service (see back cover).

Engine will not

Idle properly.

1. Fuel not reaching

carburetor.

2. Carburetor requires

adjustment.

3. Crankshaft seals worn.

4.

Compression tow.

1. Check for dirty fuel filter; replace.

Check for kinked or split fuel line;
repair or replace.

2. Contact Sears Service (see back cover).

3. Contact Sears Service (see back cover).
4. Contact Sears Service (see back cover).

- 11 -

Advertising