Static addressing pre-installation checklist, Static addressing installation – Avaya INDEX 4602 User Manual

Page 8

Advertising
background image

Page 8 - IPNC Setup

Installation Procedure

Static Addressing Pre-Installation Checklist

Before performing static addressing on the 4602 IP Telephone, verify that have
the values for the following parameters. Failure to do so may cause errors
during data entry, which will prevent the telephone from working and may have
a negative impact on your network. Consult your network administrator and print
copies of this checklist for each subnet.
1. The IP Address of the call server/gatekeeper.
2. The IP Address to be allocated to the 4602 IP Telephone.
3. The transport layer port number of the Address of the Management

Complex (call server/gatekeeper). Although this may be a value between 0
and 65535, the default value is 1719 and should not be changed unless this
conflicts with an existing port assignment.

4. The IP Address of the gateway/router
5. The IP netmask
6. The IP address of the TFTP server.

Static Addressing Installation

The usual way to assign IP addresses to IP Telephones is the automatic
method described in Dynamic Address Process on page 6. There may be times,
however, when manual assignment of IP addresses is desired.
The display on the 4602 IP Telephones accommodates up to 24 characters per
line.
Use the following procedure to invoke manual address information
programming.
1. Start manual address programming by performing one of the following

steps:
a. During normal DHCP processing, press the * key before the DHCP

process completes.

or

b. While the phone is on-hook and idle, press the following sequence of

keys on thefaceplate of the telephone:

Mute 2 3 3 7 # (Mute A D D R #)

Press

the

Mute button momentarily. Do not press this button while

pressing other keys/ buttons.

The following message is displayed:

Phone=nnn.nnn.nnn.nnn

New=_

where “nnn.nnn.nnn.nnn” is the value of the telephone.

2. Enter the IP address for the telephone followed by the # button.

The following message is displayed:

CallsSv=nnn.nnn.nnn.nnn

New=_


where “nnn.nnn.nnn.nnn” is the value of the call server/gatekeeper IP
address.

Page 8 - IPNC Setup

INDeX 4602 IP Telephone Installation Manual

Installation Procedure

38DHB0002UKCQ – Issue 2 (11/06/2003)

Advertising