Getting to know your bandsaw – Craftsman 119.214000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
d. Place the blade tension knob on to the blade tensioner {See
Fig. 4).
b. Fasten the guide rail with two each star knob screw and washer
to the table. Use the hex socket head cap screw, washer and wing
nut for correcting the working table flatness. (See Fig. 2)
c, Lay the rip fence onto the guide rail. Adjust the rip fence parallel
to the saw blade. Tighten rip fence handle by pressing downward.
(See Fig. 3)
FIG. 4
e. To ensure sufficient upright stability of the machine it should be
bolted to floor, bench or worktable. For this purpose 6mm holes
are provided in the machine’s base. (See Fig. 5)
f. The bandsaw has a 2-1/2" dust port included. (See Fig. 5)
It is recommended that when in use, the bandsaw is connected to
a suitable dust collector.
GETTING TO KNOW YOUR BANDSAW
Lock switch
Guide rail
Blade tension knob
oor iocking knob
Blade guide
/Miter gauge
Upper table turnnion-'
Lower table turnnion"
Dust poi
Blade tracking knob
■Guide post adjusting knob
-enee
otor