Save these instructions, Glossary of terms for woodworking, Rules for safe operation (continued) – Craftsman 315.212110 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

RULES FOR SAFE OPERATION (Continued)

ALWAYS STAY ALERT! Do not allow familiarity

(gained from frequent use of your saw) to cause

a careless mistake. ALWAYS REMEMBER that
a careless fraction of a second is sufficient to
inflict severe injury.

STAY ALERT AND EXERCISE CONTROL.
Watch what you are doing and use common

sense. Do not operate tool when you are tired.
Do not rush.

MAKE SURE THE WORK AREA HAS AMPLE

LIGHTING to see the work and that no obstruc­
tions will interfere with safe operation BEFORE

performing any work using your saw.

ALWAYS TURN OFF SAW before disconnecting
it, to avoid accidental starting when re-connect­
ing to power supply.

SAVE THESE INSTRUCTIONS. Refer to them
frequently and use to instruct other users. If you
loan someone this toot, loan them these instruc­
tions also.

SAVE THESE INSTRUCTIONS

GLOSSARY OF TERMS FOR WOODWORKING

Arbor

The shaft on which a blade or cutting tool is mounted.

Bevel Cut

A cutting operation made with the blade at any angle
other than 90“ to the miter table.

Crosscut

A cutting or shaping operation made across the grain
of the workpiece.

Compound Miter Cut
A compound miter cut is a cut made using a miter

angle and a bevel angle at the same time.

Freehand

Performing a cut without using a fence, miter gage,
fixture, work clamp, or other proper device to keep the
workpiece from twisting or moving during the cut.

Gum

A sticky, sap based residue from wood products.

Miter Cut
A cutting operation made with the blade at any angle

other than 90" to the fence.

Resin

A sticky, sap base substance that has hardened.

Revolutions Per Minute (RPM)

The number of turns completed by a spinning object

in one minute.

Saw Blade Path

The area over, under, behind, or in front of the blade.
As it applies to the workpiece, that area which will be,
or has been, cut by the blade.

Set

The distance that the tip of the sawblade tooth is bent
(or set) outward from the face of the blade.

Throw-Back

Throwing of a workpiece in a manner similar to a
kickback. Usually associated with a cause other than
the kerf closing, such as a workpiece not being
against the fence, being dropped into the blade, or
being placed inadvertently in contact with the blade.

Through Sawing
Any cutting operation where the blade extends

completely through the thickness of the workpiece.

Workpiece

The item on which the cutting operation is being done.
The surfaces of a workpiece are commonly referred to
as faces, ends, and edges.

Zero Clearance Throat Plate
A plastic throat plate inserted in the miter table that

allows for blade clearance. When you make your first
cut with your compound miter saw, the saw blade cuts
a slot through the throat plate the exact width of the
blade. This provides for a zero clearance kerf that
minimizes workpiece tear-out.

No Hands Zone

The area between the marked lines on the left and

right side of the miter table base. This zone is

identified by no hands zone labels placed inside the
marked lines on the miter table base.

Advertising