Craftsman 917.270752 - Manual (Page 203)

• Install new belt in reverse order of
removal.
• Make sure belt is in all pulley grooves
and inside ail belt guides.
• Install mower In reverse order of
removal instructions.
BELT INSTALLATION -
Mandrel
Pulley
Idler Pulleys
Mandrel
Pulley
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of left footrest.
• Remove mower (See “TO REMOVE
MOWER” in this section of this manual.)
• Remove belt from stationary idler and
clutching idler.
• Pul! belt slack toward rear of tractor.
Remove belt upwards from transaxle
pulley by deflecting belt keepers.
• Pull belt toward front of tractor and
remove downwards from around engine
pulley.
• Install new belt by reversing above
procedure.
TO REPLACE MOTION DRIVE BELT
TO ADJUST BRAKE
Your tractor Is equipped with an adjustable
brake system which is mounted on the
right side of the transaxle.
If tractor requires more than six (
6 ) feet
stopping distance at high speed in highest
gear, then brake must be adjusted.
• Depress clutch/brake pedal and engage
parking brake.
■ Measure distance between brake
operating arm and nut “A” on brake rod.
• If distance is other than 1-1/2", loosen
jam nut and turn nut “A” until distance
becomes 1-1/2". Retighten jam nut
against nut "A".
• Road test tractor for proper stopping
distance as stated above. Readjust If
necessary. If stopping distance is still
greater than six ( 6 ) feet in highest gear,
further maintenance is necessary.
Contact your nearest authorized sen/ice
center/department.
TRANSAXLE GEAR SHIFT LEVER
ADJUSTMENT
The transaxle should be in neutral when
the gear shift lever is in neutral (N) (lock
gate) position. The adjustment is preset at
the factory; however, if adjustment is
needed, proceed as follows:
• Make sure transaxle is in neutral (N).
NOTE: When the tractor rear wheels
move freely, the transaxle is in neutral.
• Loosen adjustment bolt in front of the
right rear wheel.
• Position the gear shift lever in the
neutral (N) position.
• Tighten adjustment bolt securely.
NOTE: If additional clearance is needed
to get to adjustment bolt, move mower
deck height to the lowest position.
23