Gas and on fill-up – Craftsman 247.388240 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

A

stopping Engine

Release blade control handle to stop the

engine and the blade.

Disconnect spark plug wire and move away

from spark plug to prevent accidental starting.

WARNING: Before using your lawn mower,

again refer to the safety rules on pages 3-5
of this manual. Always be careful.

Gas And ON Fill-Up

Engine Oil

.

Only use high quality detergent oil rated with API

service classification SF, SG or SH. Select the oil’s
viscosity grade according to your expected operating
temperature. Follow the chart below.

32°F

------^

5W30

SAE 30

Oil Viscosity Grade Chart

Use SAE30 oil;

do not use

10W40 oil.

Fill oil sump and check the oil level as follows:

a. Position the mower on level ground.
b. Clean area around oil fill plug.
c. Remove oil fill plug and dipstick.
d. Wipe dipstick clean, insert it into oil fill hole

and tighten securely.

e. Remove dipstick and check oil level. If the

oil is not upto FULL mark on the dipstick,

pour recommended oil through the oil fill

and check the level again.

Install oil fill plug and dipstick, tighten securely.

NOTE:

Although multi-viscosity oils (5W30, 10W30,

etc.) improve starting in cold weather, these

multiviscosity oils will result in increased oil

consumption when used above 329F. Check the oil

level more frequently to avoid possible engine

damage from running low on oil.

Gasoline

A

WARNING: Never fill fuel tank indoors, or
when engine is running or hot. Do not
smoke when filling fuel tank.

Clean area around gas tank cap. For location,
see Figure 10. Remove cap.

Use a funnel to prevent spillage.

Pour approximately 1.5 quarts of fresh, regular

grade, unleaded gasoline slowly to the fuel tank.

IMPORTANT: Never mix engine oil with gasoline,

Fill tank to 1/2" below the bottom of the filler
neck. Wipe any fuel spillage. Do not fill fuel tank

completely. Provide space for fuel expansion.

A

A

starting Engine

(RefertoRgure 11.)

WARNING: Be sure no one other than the
operator is standing near the lawn mower
while starling or operating.

Attach spark plug wire to spark plug. Make
certain the metal cap on the end of the spark
plug wire is fastened securely over the metal tip
on the spark plug.

WARNING: Never run engine indoors or in
enclosed, poorly ventilated areas. Engine
exhaust contains carbon monoxide, an
odorless and deadly gas.

WARNING: Keep hands, feet, hair and
loose clothing away from any moving parts
on engine and lawn mower.

Push primer three times. Wait about two
seconds between each push. In cold weather
around 55° F or below, prime five times. Do not

prime to restart a warm engine after a short

shutdown.

Hold control handle against the upper handle.
Grasp recoil starter and pull rope out slowly
until engine reaches the start of compression
cycle (rope will pull slightly harder at this point).
See Figure 11 inset. Let the rope rewind slowly.

10

Advertising