Craftsman 917.270770 User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING CHART

PROBLEM

CAUSE

CORRECTION

Poor cut - uneven
(cont’d)

• Bent blade mandrel.
• Clogged mower deck vent

holes from buildup of
grass, leaves, and trash
around mandrels.

• Replace blade mandrel.
• Clean around mandrels to

open vent holes.

Mower blades will
not rotate

• Obstruction in clutch

mechanism.

• Wom/damaged mower

drive belt.

• Frozen idler pulley.
• Frozen blade mandrel.

• Remove obstruction.

• Replace mower drive belt.

• Replace idler pulley.
• Replace blade mandrel.

Poor grass dis­
charge

• Engine speed too slow.

• Travel speed too fast.
• Wet grass.

• Mower deck not level.
• Low/uneven tire air pres­

sure.

• Worn, bent or loose blade.

• Buildup of grass, leaves

and trash under mower.

• Place throttle control in

“FAST” position.

• Shift to slower speed.
• Allow grass to dry before

mowing.

• Level mower deck.

• Check tires for proper air

pressure.

• Replace/sharpen blade.

Tighten blade bolt.

• Clean underside of mower

housing.

• Mower drive oeii worn.
• Blades improperly

installed.

• Improper blades used.

• Clogged mower deck vent

holes from buildup of
grass, leaves, and trash
around mandrels.

• Replace mower drive belt.

• Reinstall blades sharp edge

down.

• Replace with blades listed in

this manual.

• Clean around mandrels to

open vent holes.

Headlight(s) not

working (if so
equipped)

• Switch is “OFP.
• Bulb(s) burned out.
• Faulty light switch.
• Loose or damaged wiring.

• Blown fuse.

• Turn switch “ON”.
• Replace bulb(s).
• Check/replace light switch.
• Check wiring and connec­

tions.

• Replace fuse.

Battery will not
charge

• Bad battery cell(s).
• Poor cable connections.
• Faulty regulator (if so

equipped).

• Faulty alternator.

• Replace battery.
• Check/clean all connections.
• Replace regulator.

• Replace alternator.

Engine “backfires"

when turning

engine-“OFP

• Engine throttle control not

set at “SLOW"

position for 30 seconds
before stopping engine.

• Move throttle control to

“SLOW” position and allow
to idle for 30 seconds before

stopping engine.

30

Advertising