Craftsman 917.255520 - Manual (Page 17)

MAINTENANCE
AIR SCREEN (See Fig. 13)
The engine air screen must be kept free of dirt and chaff to
prevent engine damage from overheating. Clean with a
wire brush or compressed air to remove dirt and stubborn
dried gum fibers.
ENGINE COOLING FINS (See Fig, 15)
Remove any dust, dirt or oil from engine cooling fins to
prevent engine damage from overheating.
• Remove oil fill dipstick and cover opening to prevent
entry of dirt.
• Remove screws from blower housing and lift housing
off engine.
. Remove the screws securing the starter housing and
iift housing off engine.
• Use compressed air or stiff bristle brush to thoroughly
clean engine cooling fins,
• To reassemble, reverse above procedure.
MUFFLER
inspect and replace corroded muffierand spark arrester (if
equipped) as it could create afire hazard and/or damage­
SPARK PLUGS
Replace spark plugs at the beginning of each mowing
season or after every 100 hours of use, whichever comes
first. Spark plug type and gap setting is shown in "PROD­
UCT SPECIFICATIONS" on page 3 of this manual,
IN-LINE FUEL FILTER (See Fig. 16)
Fuelfiltershould be replaced once each season, iffuelfilter
becomes clogged, obstructing fuel flow to carburetor, re­
placement is required.
• With engine cool, remove filter and plug fuel line
sections,
, Place new fuel filter in position in fuel line,
• Be sure there are no fuel line leaks and clamps are
properly positioned.
• Immediately wipe up any spilled gasoline.
FiG. 16
CLEANING
» Clean engine, battery, seat, finish, etc. of all foreign
matter,
* Keep finished surfaces and wheels free of all gasoline,
oil, etc.
• Protect painted surfaces with automotive type wax-
We do not recommend using a garden hose to clean your
uni! unless the electrical system, muffler, air filter and car­
buretor are covered to keep water out. Water in engine can
result in a shortened engine iife.
17