Craftsman 152.213361 - Manual (Page 12)

FILTER AND COLLECTION BAG
TO DRUM ASSEMBLY
AWARNING
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Fig. 11
1. Thread 5/16-18 hex nut (A) onto the end of lower
support rod (B). Thread lower support rod about 1/2
inch into the tapped hole (C) on top of the blower
and motor assembly. Tighten the 5/16-18 hex nut
on the lower support rod against the blower and
motor assembly. See figure 11.
2. Place the end of filter bag hanger into the mating
end of the lower support. Hook the loop on the top
filter bag onto hook of the filter bag hanger.
See figure 4 on page 9.
Fig. 12
3. Insert locking band (D) through all the loops of filter
bag (E). Position the open end of the filter bag over
the top lip of the drum. Make certain the locking
band is positioned in the upper recessed channel
of the drum and fasten clamp (F) securely to drum.
See figure 12.
Place the second locking band through all the loops
of the collection bag, similar to the filter bag.
Place the collection bag over the lower lip of the
drum. Make certain the locking band is positioned
in the lower recessed channel of the drum and
fasten clamp securely to drum.
INTAKE PORT CAP
AND HOSE ASSEMBLY
AWARNING
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Fig. 13
1
.
2
.
Slide the collar (A) of the intake port cap (B) over
intake port (C). Make sure the collar is positioned to
the back if you intend to attach the hose at this
time. See figure 13.
Place 4-inch hose clamp (D) onto the end of 4-inch
flexible hose (E). See figure 13.
3. Slide the end of 4-inch flexible hose with 4-inch
hose clamp onto intake port and tighten securely.
IMPORTANT: When connecting a flexible hose to
intake port, DO NOT REMOVE THE INTAKE PORT
CAP COLLAR FROM THE INTAKE PORT. Slide
the collar of intake port cap further back when
attaching a flexible hose.
12