Cleaning, Service and adjustments – Craftsman 917.273390 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLEANING

• Clean engine, battery, seat, finish, etc.

of all foreign matter.

• Keep finished surfaces and wheels free

of al! gasoline, oil, etc.

• Protect painted surfaces with auto­

motive type wax.

We do not recommend using a garden
hose or pressure washer to clean your
tractor unless the engine and transmis­
sion are covered to keep water out. Water
in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.

SERVICE AND ADJUSTMENTS

A

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
SERVICE OR ADJUSTMENTS:

1. Depress clutch/brake pedal fully and set parking brake.

2. Place gearshift lever in neutral (N) position.
3. Place attachment clutch in “DISENGAGED” position.
4. Turn ignition key to “STOP” and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot

come in contact with plug.

TRACTOR

TO REMOVE MOWER
Mower will be easier to remove from the

right side of tractor.

1

.

2

.

3.

5.

6

.

Place attachment clutch in “DISEN­
GAGED” position.
Move attachment lift lever forward to
lower mower to its lowest position.
Roll belt off engine pulley.
Remove small retainer spring, and
remove clutch spring off pulley bolt.
Remove large retainer spring, slide
collar off and push housing guide out
of bracket.
Disconnect anti-sway bar from chassis
bracket by removing retainer spring.

7. Disconnect suspension arms from rear

deck brackets by removing retainer
springs.

8. Disconnect front links from deck by

removing retainer springs.

9. Raise lift lever to raise suspension

arms. Slide mower out from under trac­

tor.

MPORTANT: If an attachment other than

the mower deck is to be mounted on the
tractor, remove the front links and hook
the clutch spring Into square hole in frame.
TO INSTALL MOWER

1. Raise attachment lift lever to its highest

position.

Small Retainer Spring

Clutch Spring

Small Retainer Spring

Clutch Spring

Front Link

— Square Hole

Engine Pulley

Retainer Spring

Anti-Sway Bar

Coliar-

Housing
Guide

Retainer Springs

{Both Sides)

Large Retainer Spring

Bracket

Deflector Shield

21

Advertising