Craftsman 917.271840 - Manual (Page 10)

CHECKTIRE PRESSURE
The tires on your tractor were overinflated
at the factory for shipping purposes.
Correct tire pressure is important for best
cutting performance.
• Reduce tire pressure to PSI shown in
'‘PRODUCT SPECIFICATIONS" section
of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing
should be property leveled. See ‘TO
LEVEL MOWER HOUSING” in the
Service and Adjustments section of this
manuai.
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for
replacing motion and mower blade drive
beits in the Service and Adjustments
section of this manual. Verify that the
belts are routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your
tractor, check to see that the brake is
properly adjusted. See TO ADJUST
BRAKE” in the Service and Adjustments
section of this manual.
INSTALL MULCHER PLATE
(If previously removed)
1. Raise and hold deflector shield in
upright position.
2. Place front of mulcher piate over front
of mower deck opening and slide into
place, as shown.
3. Hook front latch into hole on front of
mower deck.
4. Hook rear latch into hole on back of
mower deck.
^CAUTION: Do not remove deflector
shield from mower. Raise and hold shield
when attaching mulcher plate and allow
it to rest on plate while in operation.
Deflector-
Shield
Mulcher
Plate
Latch
Hooks
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in
a safe place. Your mower is now ready for
discharging or installation of optional
grass catcher accessory.
.
NOTE: It is not necessary to change
blades. The mulcher blades are de­
signed for discharging and bagging also.
10