Maintenance, Maintenance schedule, General recommendations – Craftsman 247.79452 User Manual
Page 13: Hydraulic fluid, Beam and splitting wedge
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE
Maintenance Schedule
in service dates here
4*^
o
3
TS
o
L.
Q.
Check reservoir fluid
"7”
Change hydraulic fluid
Change hydraulic filter
7
Lubricate beam and wedge
0)
c
‘5)
c
UJ
Check engine oil
Change engine oil
7
Service air cleaner foam filter
7
Service air cleaner paper filter
7
Clean engine
7
Service spark plug
Remove combustion deposits
7
Service muffler
General Recommendations
•
Always observe safety rules when performing
any maintenance.
•
The warranty on this log splitter does not cover
items that have been subjected to operator
abuse or negligence. To receive full value from
the warranty, operator must maintain the log
splitter as instructed in this manuai.
•
Some adjustments wiil need to be made
periodically to maintain your unit properly.
•
All adjustments in the Service and Adjustments
section of this manual should be checked at least
once each season.
•
Follow the maintenance schedule given below.
•
Periodically check ail fasteners and make sure
these are tight.
WARNING: Always stop the engine and
disconnect spark plug wire before perform
ing any maintenance or adjustments.
Hydraulic Fluid
•
Check the hydraulic fluid level in the log splitter
reservoir tank before each use. Fluid level should
A
be 1.5" to 2" from the top of the tank (seven
gallons approximately).
•
Change the hydrau lie fluid i n the resen/oi r eve ry
too hours of operation. Disconnect the suction
hose from the bottom of the reservoir tank, and
drain the fluid into a suitable container. Refill
using only Dexron III automatic transmission fluid
or 10W non-foaming hydraulic fluid. Also, make
sure to change the hydraulic filter.
NOTE:
D rain the fluid and flush the resenrolr tank and
hoses w ith kerosene w henever any repair work is
perform ed on the tank, hydraulic pum p or valve.
C ontam inants in the fluid w ill dam age the hydraulic
com ponents. Any repair to the hydraulic com ponents
should be perform ed by S ears service center.
Hydraulic Filter
•
Change the hydraulic filter every 50 hours of
operation. Use only a 10 micron hydraulic filter.
Beam And Splitting Wedge
•
Lubricate both sides of the beam (where it
contacts the splitting wedge) with engine oil
before each use.
13