Tools required for assembly, Contents of hardware pack, Assembly – Craftsman 917.295550 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To
ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standar d
wrench sizes are listed.
{1) Utility knife
(1) Wire cutter
{1) Screwdriver
(1)Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR’S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means whan you are in the operating position (standing
behind tiller handles).
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(2) Carriage Bolts 3/8-16 UNC x 1 Gr. 5
(2) Center Locknuts 3/8-16 UNC
(1) Rat Washer 13/32 x 1 x 11 Ga.
(1) Cable Clip
(1) Owner's Manual