Craftsman 315.212220 - Manual (Page 30)

ACCESSORIES
WORK CLAMP
See Figures 42 and 43.
SCREWS HOLD
CLAMP SUPPORT
TO TABLE EXTENSION
TABLE
EXTENSION
The work clamp provides greater control by clamping
the workpiece to the fence or the saw table. It also
prevents the workpiece from creeping toward the saw
blade. This is very helpful when cutting compound
miters.
ASSEMBLE THE WORK CLAMP
To assemble and install the work clamp on the miter
saw, carefully place the saw on a stable surface
exposing the underside of the miter saw table.
■ Place the clamp support on the table extension
and secure using a small screw in each screw hole
in the top of the clamp support.
See Figure 43.
CLAMP SUPPORT
II_ _ L
Fig. 43
Holding the clamp bracket on the bracket support,
place table extension through the holes in the end
of the miter saw base and into the corresponding
extension support trapping the clamp bracket
against the saw table.
See Figure 40.
Secure with the clamp bracket screw.
Return the saw right side up.
30