Craftsman 139.53403 - Manual (Page 13)

installation
STEP 6
Instan Wall Control
LOCATE WALL PUSH BUTTON (OR ANY ADDITIONAL PUSH BUTTONS} WHERE GARAGE
DOOR IS VISIBLE, AWAY FROM DOOR AND DOOR HARDWARE AND OUT OF THE REACH
OF CHILDREN.
SERIOUS PERSONAL INJURY FROM A MOVING GARAGE DOOR MAY RESULT FROM MIS­
USE OF THE OPENER. DO NOT ALLOW CHILDREN TO OPERATE WALL PUSH BUTTON(S)
OR THE TRANSMITTER.
FASTEN THE CAUTION LABELON THE WALL NEAR WALL PUSH BUTTON AS A REMINDER
OF SAFE OPERATING PROCEDURES.
PROCEDURE: Remove about a 1/4" of insulation
from each end of the 2-strand bell wire Connect one
end to the screw terminals on the back of wall control
as shown.
Fasten the wall control to an inside garage wall with
the 8ABx1" sheet metal screws provided A con­
venient place is beside the service door and OUT OF
THE REACH OF CHILDREN..
Run the bell wire up the wall and across the ceiling to
garage door opener. Use insulated staples to secure
wire,
The receiver terminals and the antenna are located
on the back panel of the opener chassis. Position
antenna wire as shown. Then connect wire by color
to the white and red opener terminal screws.,
Top
Installation
Flange
Bottom
Installation
Fiange
Walt Control
Push Button
Back Panel
of Opener
Antenna
OPERATION OF THE LIGHTED WALL CONTROL
Press and release to open or close door
Press and release again to REVERSE door during CLOSING cycle or
to STOP door during OPENING cycle
NOTE: Wait about 1-second between commands.
WIRING INSTRUCTIONS FOR ACCESSORIES
Open Door Indicator:
To white & orange opener terminais
Outdoor Key Switch:
To red & white opener terminais
Touch Code Lock:
To red and white opener terminals
infrared Reversing System;
To while & black opener terminals
13