Maintenance – Craftsman 486.29281 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
J
OPERATION
Become familiar with all of the controls and adjustments
on the Power Rake before operating. Controls for
operating Power Rake are as follows:
SAFETY SWITCH - Must be pressed in before handle
switch can be used to start motor.
HANDLE SWITCH - Pull and hold to start and keep
motor running. When let go motor will stop and safety
switch should re-engage.
POWER CORD - Supplies electricity to the Power Rake,
make sure to connect to a power supply using only
outdoor rated extension cables.
CORD HOLDER - Holds extension cord to help keep it
out of the way and take stress oft of the handle switch
cord.
EXTENSION CORD RATINGS
(Use only outdoor rated extension cords plugged into a
ground fault receptacle.)
GAUGE
LENGTH
16 Gauge
14 Gauge
0 - 50 Feet
51 - 100 Feet
MAINTENANCE
STORAGE
MAINTENANCE
A
CAUTION:
BEFORE PERFORMING
ANY
MAINTENANCE,
MAKE
SURE
THE POWER RAKE IS TURNED OFF
AND UNPLUGGED FROM ANY POWER
SOURCE.
Clean Power Rake and bag before storing. Do not
clean with water, solvents or petroleum based
products.
Store in a dry place that is not exposed to the
elements and out of the reach of children.
Clear excess debris left in Power Rake housing after
each use.
Make sure nothing has wrapped around the tines/
tine shaft. Remove anything that has wrapped itself
around the tines/tine shaft.
Check and make sure all wing knobs and carriage
bolts are tightened. Re-tighten any loose knobs and
bolts.
Call 1 -866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE