Craftsman 486.24336 - Manual (Page 5)

• f f Attach two hitch arm mount brackets to the middle
holes frönt frame angle (bend pointing down) as
shown in figure 4. Fasten each bracket with a 5/16’x
3/4* hex bolt, a 5/16" lock washer and a 5/16* plain
hex nut. Make sure the brackets are aligned straight
and then tighten. See figure 4.
Assemble two hitch arm mount brackets to the middle
holes in the rear frame angle using two 5/16* x 3/4"
hex bolts, two 5/16* lock washers and two 5/16" plain
hex nuts. Make sure the brackets are aligned
straight and then tighten. See figure 5.
Assemble the hitch mount arms to the fouf hitch aim.:
mount brackets as shown in figure 6. Usé fbur 5/16" x
r carriage bolts, four 5/16" lock washers and four '
5/16" plain hex nuts. Do not tighten yet See figure
6 .
• Assemble the ends of the hitch mount arms together
using two 5/16" X1 -1/4" hex bolts, two 5/16" lock
washers and two 5/16" plain hex nuts as shown in
figure 7. Do not tighten yet.
• Assemble the hitch brackets to the hitch mount arms
using two 5/16" X 2" hex bolts, two 5/16" lock wash­
ers and two 5/16" plain hex nuts as shown in figure 7.
Tighten ail loose fasteners which were assembled in
figures 6 and 7.