Craftsman 315.110990 - Manual (Page 3)

OPERATION
SWITCH
See Figure 2.
To turn your light on and off, depress switch trigger.
SWITCH
TRIGGER
MULTI-POSITION
HEAD
Fig. 2
MULTI-POSITION HEAD
See Figure 2.
Your worklight has the feature of a multi-position head
that has positive stop clicks at each position. Rotate
head to the desired position as shown in the arrows in
figure 2.
SAFETY RULES FOR WORKLIGHTS
A WARNING: Do not operate flashlight or charger
near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may Ignite fumes.
A
WARNING: Lens and bulb become hot during
use:
• During or immediately after use, don't lay
worklight flat on lens surface.
• Handle worklight with care around any
flammable surface.
• If bulb has been lit, let worklight cool for
several minutes before changing bulb.
• Do not use or permit use of worklight in bed
or sleeping bags. A burn injury could result.
BULB REPLACEMENT
See Figure 3.
When purchasing replacement xenon bulb, request
recommended part number 981258-001.
TO REPLACE BULB:
■ Remove battery pack from worklight.
■ Remove the two screws securing lens cover, then
remove cover.
■ Remove old bulb from spring.
■ Position new xenon bulb in spring.
■ Replace lens cover and screws.
■ Replace battery pack.
Note: For your convenience, a bulb storage area with
extra bulb has been provided. It is located behind the
lens cover. See Figure 3.
SCREWS
LENS COVER Fig.3
To preserve natural resources, please
recycle or dispose of properly.
This product contains nickel­
cadmium batteries. Local, state or
federal laws may prohibit disposal of
nickel-cadmium batteries in ordinary
trash.
Consult your local waste authority for information
regarding available recycling and/or disposal options.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
USA
972000-671
5-99
For replacement parts information and ordering, call
this toll free number:
1-800-366-PART (1-800-366-7278)