Craftsman 917.275632 - Manual (Page 21)

Mandrel With Parking Brake “Engaged”
TO CHECK AND ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
right side of the transaxle.
If tractor requires more than five (5) feet to
stop at highest speed in highest gear on a
level, dry concrete or paved surface, then
brake must be checked and adjusted.
TO CHECK BRAKE
1. Park tractor on a level, dry concrete or
paved surface, depress clutch/brake
pedal ail the way down and engage
parking brake.
2. Place gear shift lever in neutral (N)
position.
The rear wheels must lock and skid when
you try to manually push the tractor for­
ward. If the rear wheels rotate, the brake
needs to be adjusted or the pads need to
be replaced.
TO ADJUST BRAKE
1. Depress clutch/brake pedal all the way
down and engage parking brake.
2. Measure distance between brake oper­
ating arm and nut “A” on brake rod.
3. If distance is other than 1-1/2", loosen
jam nut and turn nut “A” until distance
becomes 1-1/2". Retighten jam nut
against nut “A”.
4. Road test tractor for proper stopping
distance as stated above. Readjust
if necessary. If stopping distance is
still greater than five (5) feet in highest
gear, further maintenance is neces­
sary. Replace brake pads or contact a
Sears or other qualified service center.
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footrest.
BELT REMOVAL -
1. Remove mower (See “TO REMOVE
MOWER” in this section of manual).
NOTE: Observe entire motion drive belt
and position of all belt guides and keepers.
2. Disconnect clutch wire harness.
Remove clutch locator.
Remove belt from stationary Idler and
clutching idler.
Remove belt downward from engine
pulley and around electric clutch.
Pull belt slack toward rear of tractor.
Remove belt upwards from transaxle
pulley by deflecting belt keepers.
Remove belt from center span keeper
and pull belt away from tractor.
BELT INSTALLATION -
3.
4.
5.
6
.
7.
1
.
2
.
3.
4.
5.
6
.
7.
8
.
Carefully work new belt down between
transaxle belt keepers and onto the
Input pulley.
Slide belt into the center span keeper.
Pull belt toward front of tractor and roll
belt around electric clutch and onto
engine pulley.
install belt through stationary idler and
clutching idler.
Reinstall clutch locator and tighten nut
securely.
Reconnect clutch harness.
Make sure belt Is In all pulley grooves
and inside all belt guides and keepers.
Install mower (See “TO INSTALL
MOWER” in this section of manual).
21