Craftsman 315.101360 - Manual (Page 6)

FEATURES
KNOW YOUR HAMMER DRILL
See Figure 1.
Before attempting to use your hammer drill, familiarize
yourseif with ali operating features and safety
requirements. See Figure 1.
iV CAUTION: Carefully read through this entire
operator’s manual before using your new drill. Pay
close attention to the Rules For Safe Operation,
Warnings, and Cautions. If you use your drill
properly and only for what it is intended, you will
enjoy years of safe, reliable service.
ELECTRICAL CONNECTION
Your hammer drill has a precision built electric motor. It
should be connected to a power supply that is 120
volts, 60 Hz, AC only (normal household current).
Do not operate this tool on direct current (DC). A
voltage drop of more than 10 percent will cause a loss
of power and the motor will overheat. If your tool does
not operate when plugged into an outlet, double-check
the power supply.
APPLICATIONS
(Use only for the purposes listed below)
■ Hammer drilling in concrete and masonry.
■ Drilling in wood.
■ Drilling in ceramics, plastics, fiberglass, and laminates.
■ Drilling in both hard and soft metals.
■ Using driving accessories, such as driving screws with
screwdriver bits.
PRODUCT SPECIFICATIONS
Chuck Capacity...................................... 5/64 in. to 1/2 in.
Input.................................................120 Volts, AC, 60 Hz
Rating:...........................................................6.0 Amperes
No Load Speed........................................... 0-1,000 RPM
Hammer Speed...........................................0-43,000 BPM
Hammer Travel..............................................................025
Switch.....................................Variable Speed/Reversible
DEPTH
GAGE ROD
ADJUSTMENT
BUTTON
LEVEL
LEVEL
CHUCK KEY
CHUCK KEY
STRAP
Fig. 1
A WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a
'*** second is sufficient to inflict severe injury.
Page 6