Craftsman 917.271742 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE MOWER BLADE DRIVE
BELT
The mower blade drive belt may be
replaced without tools. Park the tractor on
level surface. Engage parking brake.
BELT REMOVAL-
1. Remove mower from tractor (See “TO
REMOVE MOWER" in this section of
this manual).
2. Work belt off both mandrel pulleys and
idler pulleys.
3. Pull belt away from mower.
BELT INSTALLATION -
4. Install new belt in reverse order of
removal.
5. Make sure belt is in all pulley grooves
and inside all belt guides.
6. Install mower in reverse order of
removal instructions.
With Parking Brake “Engaged"
Nut “A"
Mandrel
Pulley
Idler Pulleys
Mandrel
Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed In
highest gear on a level dry concrete or
paved surface, then brake must be
adjusted.
1. Depress clutch/brake pedal and
engage parking brake,
2. Measure distance between brake
operating arm and nut “A" on brake rod.
3. If distance is other than 1-9/16", loosen
jam nut and turn nut “A" until distance
becomes 1-9/16". Retighten jam nut
against nut “A".
4. Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact a Sears or other qualified
service center.
adjustment is necessary contact your
nearest authorized service center/
department
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there Is a
belt installation guide decal on bottom
side of left footrest.
1. Remove mower (See “TO REMOVE
MOWER’ in this section of this
manual.)
Remove belt from stationary idler and
clutching Idler.
Full belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades.
Pull belt toward front of tractor and
remove downward from around
engine pulley.
Install new belt by reversing above
procedure.
2
.
3.
4.
5.
24