Craftsman 358.352680 - Manual (Page 17)

TROUBLE SHOOTING CHART
TROUBLE CAUSE REMEDY
Engine will not
start or will run
only a few
seconds after
starting.
• Ignition switch off.
• Engine flooded.
• Fuel tank empty.
• Spark plug not firing.
• Fuel not reaching
carburetor.
• Carburetor requires
adjustment.
• None of the above.
• Move Ignition switch to ON.
• See “Starting Instructions.”
• Fill tank with correct fuel mixture.
• install new spark plug.
• Check for dirty fuel filter; replace.
Check for kinked or split fuel line; |
repair or replace.
• See “Carburetor Adjustments.”
• Contact Sears Service.
Engine will not
idle property. • Idle speed set too high
or too low.
• Low Speed Mixture
requires adjustment.
• Crankshaft seals worn.
• Compression low.
• None of the above.
• See “Carburetor Adjustments.”
• See “Carburetor Adjustments.”
• Contact Sears Service.
• Contact Sears Service.
• Contact Sears Service.
Engine will not
accelerate,
lacks power,
or dies under
a load.
• Air fitter dirty.
• Spark plug fouled.
• Carburetor requires
adjustment.
• Exhaust ports or muf­
fler outlets plugged.
• Compression low.
• None of the above.
• Clean or replace air filter.
• Clean or replace plug
and regap. j
• See “Carburetor Adjustments."
• Contact Sears Service.
• Contact Sears Service.
• Contact Sears Service.
Engine smokes
excessively.
• Choke partially on.
• Fuel mixture incorrect.
• Air filter dirty.
• High Speed Mixture
requires adjustment.
• Crankcase leak.
• Adjust choke.
• Empty fuel tank and refill with
correct fuel mixture.
• Clean or replace air filter.
• See “Carburetor Adjustments.”
• Contact Sears Service.
Engine runs
hot.
«
• Fuel mixture incorrect.
• Spark plug incorrect.
• High Speed Mixture
set too lean.
• Exhaust ports or muf­
fler outlets plugged.
• Carbon build-up on
muffler outlet screen.
Fan housing/cylinder
fins dirty.
None of the above.
• See “Fueling Your Unit.”
• Replace with correct plug.
• See “Carburetor Adjustments.”
• Contact Sears Service.
• Clean spark arrestor screen.
• Clean area.
' Contact Sears Service.
Oil inadequate
for bar and
chain
lubrication. •
Oil tank empty.
Oil pump or oil filter
clogged.
Guide bar oil hole
blocked.
Fill oil tank.
Contact Sears Service.
Remove bar and clean.
17