Assembly – Craftsman 286.17589 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DESCRIPTION
Before attempting to use any tool, be sure to familiarize with all the operating
features and safety instructions.
A
WARNING:
DO NOT let familiarity with your saw make you careless.
Remember that a careless fraction of a second is sufficient to cause severe injury.
KNOWYOUR SAW (SEE Fig. 1)
Your Twin Cutter saw has many buift-in convenience features for fast, efficient cutting.
These features include a innovative 2-blade system with special blades that spin in
opposite directions to provide smooth, clean cuts. It also includes a pre-installed
blade lubricating system for use when cutting aluminum, copper, stainless steel and
cast iron. The auxiliary handle mounts on the top of the saw to provide maximum
support and ease of handling.
For your convenience, there is no assembly required foryourTwIn Cutter Saw. The
special 2-blade cutting system and the wax lubricating system are already installed.
Lock Nut
Assist Handle
Lower Blade
Guard Handle
Wax
Lubricating
Stick
Upper Blade Guard
Fig. 1
On/Off Switch
Wrench
Wax Lubricating
System Knob
Blades
Motor
Housing
Lower Blade Guard
PRODUCT SPECIFICATIONS
Input
6 Amps
Output
.96-Peak HP
Blade Diameter
5 in. (127mm)
Rating
120voits,60 Hz AC
No-load Speed
5500 RPM
Maximum Depth of Cut
wood (1 inch) metal (with a wait or sheet thickness of 1/16 in.)
ASSEMBLY
UNPACKING
YourTwin Cutter Saw has been shipped completely assembled. Inspect the saw
carefully to make sure that no breakage or damage has occurred during shipping.
If any parts are damaged or missing return the saw to your nearest Sears Store to
have it replaced.
A
WARNING:
If any parts are missing, DO NOT operate this saw until the
missing parts are replaced. Failure to do so could result in possible serious
personal injury