Additional items needed, Assemble scoop, Step 1: install two bolts – Craftsman 486.248473 User Manual
Page 7: See figure 1), Step 2: install pin stop bracket (see figure 1), Step 3: install lift frame assembly, See figure 2)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOOLS REQUIRED FOR ASSEMBLY
(1)
Standard Screwdriver
(2)
15/16" Wrenches (one should be box-end)
(2)
3/4" Wrenches
(2)
9/16" Wrenches
(2)
1/2" Wrenches
(2)
7/16" Wrenches
(1)
3/8" Wrench
ADDITIONAL ITEMS NEEDED
Ruler or Tape Measure
Grease
REMOVE PARTS FROM CARTON
•
Remove the hardware pack and all loose parts from
the carton.
•
Lay cardboard on floor to help prevent scratching of
painted parts.
•
Lay out and identify all the parts and hardware as
shown on pages 4 through 6.
ASSEMBLE SCOOP
STEP 1: INSTALL TWO BOLTS
(SEE FIGURE 1)
•
Assemble two 3/8" x 1 -1/4" hex bolts (D) and 3/8" hex
nuts (Q), threading the nut all the way onto the bolt
until it is tight against the head of the bolt.
*
Install a nut/bolt assembly into the bucket assembly
and fasten using a 3/8" nylock nut (R). Tighten.
Repeat for the other side.
STEP 2: INSTALL PIN STOP BRACKET
(SEE FIGURE 1)
• install the pin stop bracket to the top of the bucket
assembly using four 5/16" x 1" hex bolts (F), eight
5/16" washers (DD) and four 5/16" nylock nuts (S).
Leave the bolts loose enough that the position of the
pin stop bracket can be adjusted later.
STEP 3: INSTALL LIFT FRAME ASSEMBLY
(SEE FIGURE 2)
* Apply grease to the mounting surface of the bucket
assembly and the inside of the lift frame arms.
•
Assemble the lift frame assembly to the bucket
assembly using two 5/8" x 1-1/2" hex bolts (A) and
5/8" nylock nuts (M). Tighten, then loosen the nuts
1/4 turn, or until the lift frame pivots freely.