Checklist – Craftsman 919.762500 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. •
Cut
tie wrap off of high pressure hose. Unwind
high pressure hose to attach
the
threaded end to
the gun.
6. • Connect chemical hose to the chemical injector
hose barb on pump.
8. • Your units
pump is
shipped
with
a temporary
plug that must be replaced with a breather cap.
This
plug
is located over the pump's oil port.
Unscrew and remove
this
plug. Remove the
breather cap from the bag attached to the plug
and install it in the pump’s oil port.
CAUTION:
Failure to replace the plug will result
in serious pump damage.
9. • Place assembled gun and wand on pressure
washer's handle bracket as shown.
7. • Connect high pressure hose to the quick connect
outlet on pressure washer.
NOTE: Always
keep hose away from engine
muffler.
Checklist
Before going any further please review
the
following:
• Be sure you have completed assembly instruction.
• Double check all fittings to be sure they are tight.
IMPORTANT:
Before any attempt to
start
your pres
sure washer be sure to check engine
oil
(See Operation
under Engine Oil, page 9.)