Craftsman 917.270631 - Manual (Page 25)

TO REPLACE HEADLIGHT BULB
® Raise hood.
® Pud bulb holder out of the hole in the
backside of the grill.
<» Replace bulb in holder and push bulb
holder securely back Into the hole in the
backside of the grill.
® Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre­
vent it from starting.
“ Check wiring. See electrical wiring dia­
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
» Raise hood.
«» Unsnap headlight wire connector.
8 Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
® To replace, reverse above procedures.
ENGINE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non­
road engine repair establishment or indi­
vidual. Warranty repairs must be per­
formed by an authorized engine manufac­
turer’s service outlet
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec­
essary. Check adjustment as described
below before loosening cable. If adjust­
ment Is necessary, proceed as follows:
» With engine not running, move throttle
control lever from slow to choke posi­
tion. Slowly move lever from choke to
fast position.
8 Check that holes “A” in governor control
lever and hole in governor plate line-up.
If holes “A” are not aligned, loosen
clamp screw and move throttle cable
until holes are aligned. Tighten clamp
screw securely.
Governor Governor
Control Lever Control Plate
25