Service and adjustments, Sharpening or replacing chipper blades, Storage – Craftsman 486.24515 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
SHARPENING OR REPLACING CHIPPER
BLADES
• Disconnect the spark plug wire and move away from
the spark plug.
• Remove the access plate by removing two hex lock
nuts. See figure 38.
• Locate one of the chipper blades in the access plate
opening by rotating the impeller assembly by hand.
Remove the blade using a 3/16" alien wrench on the
outside of the blade and a 1/2" wrench on the impel
ler assembly, inside the housing.
.
• Remove the other blade in the same manner,
• Replace or sharpen blades. If sharpening, make
certain to remove an equal amount from each blade.
Reassemble in reverse order,
NOTE: Make certain the blades are reassembled with
the sharp edge facing upward, as viewed from the access
plate opening.
FIGURE 38
STORAGE
Clean the engine and the entire unit thoroughly.
Refer to engine manual for correct engine storage
instructions.
If storing in an unventilated or metal storage shed,
coat metal parts with light oil or silicone to prevent
rust.
Store unit in a clean, dry area.
21