Unassembled parts, Assembly/pre-operation, Tools required for assembly – Craftsman 917.28925 User Manual
Page 7: To remove tractor from, Carton, Unpack carton, Before removing tractor from skid, To check battery, Adjust seat
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UNASSEMBLED PARTS
Keys
Slope Sheet
(1) Oil Drain Tube
For Future Use
(2) Keys
ASSEMBLY/PRE-OPERATION
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 1/2" wrench Tire pressure gauge
(2) 7/16" wrenches Utility knife
Pliers
When right or left hand is mentioned in this
manual, itmeanswhenyouareintheoperating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and
parts cartons from carton .
•
Cut along dotted lines on all four pan
els of carton. Remove end panels and
lay side panels flat.
•
Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
TO CHECK BATTERY
1. Lift hood to raised position.
NOTE: Ifthis battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
• For battery and battery cable installation
see "REPLACING BATTERY" in the
"Service and Adjustments" section in
this manual.
ADJUST SEAT
1
.
2
.
3.
Sit in seat.
Lift up adjustment lever (A) and slide
seat until a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down.
Release lever to lock seat in position.