Craftsman 917.272762 User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center

PROBLEM

CAUSE

CORRECTION

Will not start

1. Out of fuel.

1. Fill fuel tank.

2. Engine not “CHOKED”

2. See “TO START ENGINE”

properly.

in Operation section.

3. Engine flooded.

3. Wait several minutes before

attempting to start.

4. Bad spark plug.

4. Replace spark plug.

5. Dirty air filter.

5. Clean/replace air filter.

6. Dirty fuel filter.

6. Replace fuel filter.

7. Water In fuel.

7. Drain fuel tank and carbure­

tor, refill tank with fresh

gasoline and replace fuel

filter.

8. Loose or damaged wiring.

8. Check all wiring.

9. Carburetor out of adjustment.

9. See “To Adjust Carburetor”

in Service and Adjustments
section.

10. Engine valves out of

10. Contact a Sears or other

adjustment.

qualified service center.

Hard to start

1. Dirty air filter.

1. Clean/replace air filter.

2. Bad spark plug.

2. Replace spark plug.

3. Weak or dead battery.

3. Recharge or replace battery.

4. Dirty fuel filter.

4. Replace fuel filter.

5. Stale or dirty fuel.

5. Drain fuel tank and refill with

fresh gasoline.

6. Loose or damaged wiring.

6. Check all wiring.

7. Carburetor out of adjustment.

7

See “To Adjust Carburetor” in

Service and Adjustments
section.

8. Engine valves out of

8. Contact a Sears or other

adjustment.

qualified service center.

Engine will not

1. Brake pedal not

1. Depress brake pedal.

turn over

depressed

2. Attachment clutch is

2. Disengage attachment

engaged.

clutch.

3. Weak or dead battery.

3. Recharge or replace battery.

4. Blown fuse.

4. Replace fuse.

5. Corroded battery terminals.

5. Clean battery terminals.

6. Loose or damaged wiring.

6. Check all wiring.

7. Faulty ignition switch.

7. Check/replace ignition

switch.

8. Faulty solenoid or starter.

8. Check/replace solenoid or

starter.

9. Faulty operator presence

9. Contact a Sears or other

switch{es).

qualified service center.

Engine clicks but

1. Weak or dead battery.

1. Recharge or replace battery.

will not start

2. Corroded battery terminals.

2. Clean battery terminals.

3. Loose or damaged wiring.

3. Check all wiring.

4. Faulty solenoid or starter.

4. Check/replace solenoid or

starter.

Loss of power

1. Cutting too much grass/too

1. Set in “Higher Cut” position/

fast.

reduce speed.

2. Throttle in “CHOKE” position.

2. Adjust throttle control.

Advertising