To replace fuse (see fig. 27), To remove hood and grill (see fig. 28), To replace headlight bulb – Craftsman 917.255561 User Manual
Page 22: Interlocks and relays, Interlocks and relays .. .............. ,-22, Service and adjustments
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO REPLACE FUSE (See Fig. 27)
Replace with 30 amp automotive-type piug-in fuse, The
fuse holder is located in the engine compartment, directly
in front of the dash.
TO REMOVE HOOD AND GRILL (See Fig. 28)
TO REPLACE HEADLIGHT BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
. Replace bulb In holder and push bulb holder securely
back into the hole in the backside of the grill,
•
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting
•
Check wiring. See the electrical wiring diagram in the
Repair Parts section of this manual,
CAUTION: Muffler is hot. Be careful
when removing retainer springs from
hood pivot brackets.
Raise hood.
Unsnap headlight wire connector.
Remove retainer springs from hood pivot brackets.
Stand in front of tractor. Grasp hood at sides, tilt
forward and lift off of tractor
To reinstall, slide hood pivot brackets into slots in
frame. Replace retainer springs.
Reconnect headlight wire connector and close hood.
22