Craftsman 315.108990 - Manual (Page 12)

OPERATION
Hold your saw firmly with both hands.
See Figure 14.
RIGHT Fig. 14
Squeeze the switch trigger to start your saw. Always
let the blade reach full speed, then guide your saw
into the workpiece.
WARNING: The blade coming in contact with
the workpiece before it reaches full speed could
cause your saw to "kickback" towards you
resuiting in serious injury.
When making a cut use steady, even pressure.
Forcing causes rough cuts, could shorten the life of
your saw and could cause "kickback."
REMEMBER;
When sawing through work, the lower blade guard
does not cover the blade, exposing it on the
underside of work. Keep your hands and fingers
away from cutting area. Any part of your body
coming In contact with the moving blade will
result in serious injury.
After you complete your cut release the trigger and
allow the blade to come to a complete stop. Do not
remove your saw from workpiece while the blade
Is moving.
iV CAUTION: When lifting your saw from the
workpiece, the blade is exposed on the
underside of your saw untii the lower blade guard
closes. Make sure lower guard is closed before
setting your saw down on work surface.
TO CROSS CUT OR RIP CUT
When making a cross cut or rip cut, aiign your line of
cut with the outer blade guide notch on the saw base
as shown in Figure 15.
TOP VIEW OF SAW
FRONT
OF SAW
—
- Vs
BLADE
GUIDE NOTCH
ALIGN OUTER BLADE GUIDE NOTCH ON
SAW BASE WITH LINE OF CUT AS SHOWN
GUIDELINE
WHEN MAKING CROSS CUTS OR RIP CUTS Fig. 15
Since blade thicknesses vary, always make a trial cut
in scrap material along a guideline to determine how
much, if any, the guideline must be offset to produce
an accurate cut. Note: The distance from the line of
cut to the guideline is the amount you should offset
the guideline.
12