Cleaning the aperture section, Proper care of the camera – Canon DS-8 User Manual
Page 55
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cleaning the Aperture Section
The aperture section, the section where the fiim is held by the pres
sure plate, should always be kept clean. It is best to clean this
section with a blower or a soft brush whenever new film is loaded.
Do not use anything hard, such as a metal brush.
The pressure plate can be removed by unscrewing its tightening
screw.
■ When loading film, check to see that the sprocket guide and pres
sure plate tightening screws are not loose to secure the positive film
abvance.
Proper Care of the Camera
1
Do not put fingerprints or other stains on the lens. Wipe
‘ gently with silicon cloth when removing stains and use a blower
for removing dust.
2
When using the camera on a rainy day or at the beach, moisture
and salt air adhere to it, which can result in stains, rust, and
corrosion. Remove them with a soft dry cloth as soon as possible.
3
ln hot climates, do not leave the camera insideclosedautomobiles
duringthe daytime or in direct sunlight.
4
In extremely cold areas, expose the camera gradually to the
outer air to prevent the lens from clouding. Since the perform
ance of the batteries drops at temperatures of 0°C (32°F), keep them
warm with your body temperature until just before use.
5
Before putting the camera into its case, be sure to turn the
master switch to "OFF".
6
When the camera is not to be used for a prolonged period of time,
remove the penlight batteries. Do not keep naphthalene or cam
phor near the camera.
"1
Periodic checks, cleaning and overhaul will prolong the life of the
• camera.