Scarlett SC-1046 - Manual (Page 4)

www.scarlett-europe.com SC-1046 4
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Please read this manual before use and save it for future reference.
· Before first switching on check that the voltage indicated on unit rating label corresponds the
mains voltage in your home.
· For home use only. Do not use for any other purposes.
· Do not touch rotating beaters with the hand or any objects!
· Do not use the beaters to mix hard ingredients, such as a frozen butter. Mixing heavy
ingredients may cause motor damage.
· Never wash mixer in water; if the mixer accidentally was immersed or spilled, immediately
unplug it, completely dry and let it checked in service center.
· Before unplug the appliance, ensure that the speed switch is at position. Do not pull the
cord, but the plug only.
USING YOUR MIXER
· Push the beaters into slots, slightly turning until locking into proper position.
· Immerse the beaters into the products mixture.
· Plug the mixer into the wall socket.
· Slide the speed control switch to the desired speed.
· When the desired consistency is reached, slide the speed control switch to position. Wait
until the beaters stops and unplug mixer.
· Press beaters release button and remove the beaters.
NOTE: Set the speed depending on type of food. Always start to work at low speed, and then
gradually increase it. As the mixture during processing becomes thicker, increase power by
switching to a higher speed.
CAUTION: When inserting the dough hooks, remember that the rod with the large washer should
be inserted into the right-hand slot, and the one with the smaller washer into the left-hand slot.
This is to avoid the risk of ingredients spilling over the rim of the utensils/receptacle.
MIXING GUIDE
SPEED DESCRIPTION
1,2 This is a good starting speed for mixing dry foods.
3 The best mode to mix liquid ingredients and for making sauces and dressings.
4 For mixing cakes, cookies, puddings, desserts.
5 For whipping cream, beating eggs, etc.
· To prevent motor overheating do not work continuously longer than 10 minutes and obligatory
stop mixer for no less than 10 min., letting it cool to room temperature.
CLEAN AND CARE
· Always unplug the unit from the power supply before cleaning.
· Wash beaters with warm soapy water and then dry.
· Clean the body with a damp cloth and never wash or spill mixer with water.
· Do not use abrasive cleaners, metal brushes and sponges, organic solvents or aggressive
liquids.
RUS
·
.
· ,
, , .
· .
.
· !
· , ,
. .
· .
, ,
.